Brew Express BE-110 Spezifikationen PDF herunterladen (Seite 15)

5. Bring1/4”water supply line to cut opening. Bring water

line through grommet in rough-in-box (See Supply Detail).

 Sliderough-in-boxintoopeningwhilepullingabout18”of

water line through grommet hole. Secure rough-in-box to wall

stud with sheet rock screws.PURGEWATERLINEbyrunning

water to clean any possible debris. Cut water line to length

 (approx.3”)insiderough-in-box and attach male quick

connector. Use wrench to tighten and secure.

See Male Connector Detail and ﬁgures 5 and 7.

IMPORTANT:

Water line to brewer must be ﬂushed and a ﬁlter installed.

Should debris clog brewer system ALL WARRANTIES VOID.

Check for leaks.

4. Place rough-in-box on a towel or cardboard to protect

counter surface. Bring power supply wire from source to cut

opening as shown in Figure 4. Minimum 12-2 wire required.

Besuretohaveanadditionallengthofapproximately18”at

rough-in-box opening for installation of box. Remove power

panel cover. Install strain relief (not supplied) in hole. Run

power supply wire through strain relief and secure power

supply wire (See Supply Detail, page 11). Connect power

supply wires to power panel supply wires and secure with

wire nuts (See Wiring Detail, page 11). Connect green wire

to green wire, black to black and white to white.

BREWER INSTALLATION

Figure 5

Supply Detail Wiring Detail

Male Connector Detail

Figure 4

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Keine Kommentare

Brew Express BE-110 Spezifikationen Seite 15